Service manual

51
bracket when it is outside the arrowed position. (Refer to
⑤
)
◆
Suspension bolt stays inside the cap of indoor unit. Never remove the cap.
5) Lift the unit and slide forward unit the dent. (Refer to
⑥
)
6) Screw tightly both hanger bracket-setting bolts (M8). (Refer to
④
)
7) Screw tightly both hanger bracket-xing bolts (M6) to prevent the movement of the indoor unit. (Refer to
④
)
8) Adjust the height so that rear side of the drainpipe slightly inclines to improve drainage.
Caution
！
◆
Adjust the height by turning the nut with a spanner.
◆
Insert the spanner from the hanger bracket opening. (Refer to
⑦
)
In case of hanging
It is possible to install using inward facing hanger brackets by not removing the brackets from the indoor unit. (Refer
to
⑧
)
Be sure to use only the specied accessories and parts for installation work.
Celling
40 or less
Hanger bracket
Suspension bolt
Celling slab
BOLT POSITION INWARD
Hanger bracket
Hanger bracket
setting bolt(M8)
Hanger bracket
fixing bolt(M6)
Hanger bracket
③
④
⑤
⑥
⑦
⑧
49