Service manual

44
f. Make sure that there are enough space for care and maintenance. Make sure that the weight between the indoor
unit and ground is above 1800mm.
g. When installing the steeve bolt, check if the install place can stand the weight 4 times of the unit’s. If not,
reinforce before installation. (Refer to the install cardboard and nd where should be reinforced)
Note!
There will be lots of lampblack and dust stick on the acentric, heat exchanger and water pump in dining room and
kitchen, which would reduce the capacity of heat exchanger, lead water leakage and abnormal operation of the water pump.
The following treatment should be taken under this circumstance:
a. Ensure that the smoke trap above cooker has enough capacity to obviate lampblack to prevent the indraft of the
lampblack by the air conditioner.
b. Keep the air conditioner far from the kitchen so that the lampblack would not be indraft by the air conditioner.
★
Important notice:
◆
To guarantee the good performance, the unit must be installed by professional personnel according with this
instruction.
◆
Please contact the local SINCLAIRspecial nominated repair department before installation. Any malfunction caused
by the unit that is installed by the department that is not special nominated by SINCLAIR would not deal with on time by the
inconvenience of the business contact.
4.2.3 Dimension Data
Dimension of ceiling opening and location of the hoisting screw (M10)
A
Refrigerant pipe
780(
Gaps between hoisting screw rods
)
840( Indoor unit)
890*(Ceiling opening)
950(
Decorated surface boards
)
Hoisting screw (X4)
950(Decorated surface boards )
890(
Ceiling opening
)
840(
Indoor unit
)
680(Gaps between hoisting screw rods)
Install dimension of mode MC-C24AI
42