Service manual

33
CONTROL
the main unit will close automatically).
2) Press MODE to select the desired running mode.
3) Press
＋
or
－
to set the desired temperature (it is unnecessary to set the temperature under the AUTO mode.)
4) Press FAN to set the fan speed, AUTO, LOW, MID, or HIGH.
5) Press to select the swing angle.
3.2.3 Guide for Optional Operation
◆
About BLOW
This function indicates that moisture in the evaporator of the indoor unit will be dried after the unit is stopped to
avoid mould.
a. BLOW ON: When press the ON/OFF button to turn off the unit, the indoor fan will continue running for about
another 10 minutes at the low speed. In this case, the indoor fan can be stopped directly by pressing the button BLOW.
b. BLOW OFF: When press the ON/OFF button to turn off the unit, the whole unit will be stopped completely.
◆
About AFTERHEAT BLOW
Under the Heat mode or Auto Heat mode, if the unit is turned off, the compressor and outdoor fan will stop running
immediately and the upper and lower guide board will rotate to the horizontal position, while the indoor fan will still run at
the low fan speed. Then, 10 seconds later, the unit will stop completely.
◆
About AUTO RUN
When AUTO RUN is selected, the setting temperature will not be displayed on the LCD and the unit will choose the
suitable running mode automatically in accordance with the room temperature.
◆
About TURBO
If this function is activated, the unit will run at super-high fan speed to cool or heat quickly so that the ambient
temperature will approaches the preset temperature as soon as possible.
31