User manual

24
REPAIRS
A-bike Plus User Manual
25
REPAIRS
Removing the rear wheel from your A-bike Plus.
This is a two stage operation. First the brake band is moved out of
the way. Then the wheel is removed.
1. Place bike in folded position. (this
slackens the brake cable)
2. Remove two Brake Assembly bolts.
3. With the bike folded, use the slack in
the brake cable and withdraw the Brake
Assembly out of the crank casing. Do
not remove cable from Brake band.
4. Remove rear axle bolts. Please
note that the bolt on the right hand
side of the bike (also highlighted by a
red mark) is Left-hand threaded and
therefore can be undone by turning
clockwise, standard bolts are undone
by turning them counter-clockwise.
To undo both bolts you must firmly hold
the wheel still while turning each bolt.
5. Slightly spread open crank casing to
allow the Drive Axle to drop out, take
the chain off the sprocket and drop the
wheel out.
6. Refitting is the reverse of removal. Check that the brake band is
correctly aligned on the wheel and that the fasteners are securely
tightened. When refitting Brake Assembly fasteners make sure that
the anti-vibration washers are refitted too.
Fixing a puncture (2)