Installation Guide

5/27/2022Revised
Installation / Installation / Instalación
Step 10 – Rotate the clip, tighten to secure sink, do not over tighten as
damage can result. (Figure 5)
Step 11 – Take out fastener, screws and plastic nuts, for under mount
installation. Drill hole from the back side of countertop, and put
the plastic nut in it for connecting screws. Attach the iron
fastener with screws, make sure one end of fastener holds the
sink rim, while another end touches the backside of
countertop. (Figure 6)
Step 12 – Install drain and water supply fittings as necessary. and Run
water into the sink and check for leaks.
Dual Mount
Stainless
Steel Sinks
Step 9 – Place the sink into the cut out opening and be sure it is
properly seated, make sure the sink rim covers
caulking all round. Insert the clips into the U shape
channels at the backside of the sink rim.
(recommended clip placement, two clips on each rim,
Figure 4)