Installation Guide

5/27/2022Revised
Installation / Installation / Instalación
Luxart dual mount stainless steel handmade sink, which can either installed above the countertop or installed
under the countertop. It is recommended that all countertops be cut by an approved or certified installer and the
sinks be installed by the installer whenever possible. The countertop/sink unit ideally should be installed as one
on the jobsite.
Step 1 – Remove your new sink from the carton. Use caution as sink edges
may cause minor cuts. Wear safety gloves for your protection.
Step 2 – If you are replacing old sink, remove old one and verify existing
countertop opening will fit your new sink by setting it temporarily.
Step 3 – If you are installing a sink to a new counter top, please follow
directions as shown, and choose top mount installation or under mount
installation cut out lines accordingly
Step 4 – Place paper template on the counter top in desired position, tape the
template in place and trace completely outside line using soft lead
pencil.(Figure 1).
**Templates are supplied as a guide. We recommend using the actual sink for the most accurate cut.**
Dual Mount
Stainless
Steel Sinks
Step 5 – Drill hole at the inside corner of the cutout lines.
Step 6 – Using a jig saw, start cutting from the drilled hole along
the cutout line.(Figure 3)
Step 7 – Apply caulking compound around the perimeter of the
cutout opening.
Step 8 – Attach faucet and strainer as necessary according to the
manufacturer’s instructions. (Verify your sink installation
channel and clips that come with the sink and follow
proper instructions, STEP 9 is only followed when this sink
installed as top mount style, if this sink is installed as
under mount style, please proceed to STEP 11 directly.)