User manual

sinaCAM Installation
User Manual Rev.: E 21
7.9 Installing Lenses
 Attach C-mount lenses, suitable for 2/3” CCD cameras, to the standard C-mount thread of the remote
heads.
 In case of B4-mount or PL-mount lenses use the corresponding adapters (option).
7.10 Adjusting the Lens Scale Position
Depending on filming situations, it can be necessary to equip a lens at a different angle than usual for the
lens scale to remain readable. For this, sinaCAM remote camera heads support 12 different positions for
the lens mount, each 30° apart. The lens mount is held in the chosen position by the lens mount lock, with
the lens scale on top by default.
Figure 13: Adjusting the Lens Scale Position
To adjust the lens scale position follow these steps:
 Remove the screw from the lens mount lock’s lower screw hole, then partially screw it into the upper
one (1).
Note: The screw will not go all the way in.
 Grip the screw head to pull out the lens mount lock (2).
 Make sure the locking lever is in the open position (3).
 You can now adjust the position of the lens (4).
Note: Inside, the lens mount is equipped with 12 holes (each 30° apart) for
the lens mount lock.
 Choose one of the valid positions, then reinsert the lens mount lock (5) to fix
the lens mount in its place.
 Move the screw back into the lower screw hole of the lens mount lock and
tighten it (6).
 Then move the locking lever back into the closed position (7).