Installation Guide

Step 3: Installing Fence Brackets
If posts are to be installed in level ground attaching brackets in advance
of post installation is easiest when using a measuring template for faster
repetitive bracket installation. It is easier to change a bracket in the field if
necessary than to install brackets once posts are installed in the ground.
When screwing the bracket to the post, use the hole that is as close to the
top of the bracket, as you are able.
Installed brackets provide a leveling point on each post.
Distance from Top of Post to Support Bracket Surface
Note: Brackets come packaged at the tip of the
post during shipping. They must be removed
and reattached in the channel of the post at
the desired height during installation.
- Dig a hole 12" in diameter
- Bell the bottom of hole
- Holes should be a minimum of 24" deep
for 4ft panels and 30"-36" deep for 6ft
panel. However, please consult your
local building codes
- Fill hole around post with concrete mix
(sand, gravel, cement) approximately
2" - 4" below grade. Posts must have at
least 18" of the post in concrete.
Panel Size 4' 6' 8'
Bracket
Location
50" 74" 98"
Tip
Tip
4