Instruction manual

SIMTECH
Phone: [phone] • Fax: [phone]
www.SimtechUSA.com
20
WeldTech - MiniPlast Instruction Manual
1.060606
7. Maintenance and Repair
7.1. General
Replace damaged parts immediately, be particularly care full with electrical parts.
Dirt and wetness are very good current conductors.
Prescribed maintenance and inspection works should be performed in time. The
DVS gives the advice of inspection works after 1 year.
For machines with a specially high usage percentage the testing cycle should be
shortened .
The works should be performed at the SIMTECH company or by an authorized
partner.
7.2. Clamping Elements
• For a long service life clean and grease regularly the threaded spindles and the joint parts
which are used for clamping the pipes.
7.3. Planer
• Do not lay the planer on its blades !
• Check the blades of the planer for sharpness, turn them if necessary (grinded on both sides,
max. thickness of the shavings: 0,2 mm !).
7.4. Storage
• Cover the guide bars and the spindle with a thin oil film.
• Store dry.
I

I
