Instruction manual

SIMTECH
Phone: [phone] • Fax: [phone]
www.SimtechUSA.com
18
WeldTech - MiniPlast Instruction Manual
1.060606
6. Welding Tables
PP Welding Table
Diameter Weld Beginning Melt Pressure Heating Change Over Time Weld Cooling
& Wall Thickness Temp °C & Bead Height Time (Remove Heater Pressure Time Before
(Kg./Force) (Pressure at & Gradually (Kg./Force) Removing
Near 0 Lbs. Increase to Clamps
Force) Weld Pressure)
Seconds
Pressure Height Seconds
Change Bring To
Minutes
Over Pressure
½” PN3.2 - - - - - - - -
½” PN6 - - - - - - - -
½” PN10 210 1 1/32” 30 3 4 1 3
¾” PN3.2 - - - - - - - -
¾” PN6 - - - - - - - -
¾” PN10 210 1 1/32” 35 3 4 1 3
1” PN3.2 - - - - - - - -
1” PN6 - - - - - - - -
1” PN10 210 2 1/32” 40 4 4 2 4
1 ¼” PN3.2 - - - - - - - -
1 ¼” PN6 - - - - - - - -
1 ¼” PN10 210 3 1/32” 45 4 4 3 5
1 ½” PN3.2 - - - - - - - -
1 ½” PN6 - - - - - - - -
1 ½” PN10 215 4 1/32” 50 5 6 4 6
2” PN3.2 - 2 1/32” 30 3 4 2 3
2” PN6 210 4 1/32” 45 4 4 4 4
2” PN10 205 6 1/32” 60 5 6 6 7
2 ½” PN3.2 - 3 1/32” 35 4 4 3 4
2 ½” PN6 210 6 1/32” 55 5 6 6 5
2 ½” PN10 205 9 1/16” 75 5 7 9 8
3” PN3.2 - 5 1/32” 35 4 4 5 5
3” PN6 205 8 1/32” 60 5 6 8 8
3” PN10 200 13 1/16” 90 6 8 13 10
4” PN3.2 210 7 1/32” 40 4 5 7 5
4” PN6 205 12 1/32” 70 5 7 12 9
4” PN10 200 19 1/16” 100 6 10 19 12
SR45 = PN3.2; SR90 = PN6; SR150 = PN10; SR232 = PN16