Installation manual

Simrad SP90

851-164510 / Rev.E

C15 - Transceiver Unit

This is a data cable from the Sonar Interface Unit in the

wheelhouse to the Transceiver Unit in the sonar room. The cable

is included in the standard delivery with a length of 100 meters,

and it has a pre-connected plug in the Sonar Interface Unit end.

1 Run the 100 m data cable from the wheelhouse to the

sonar room.

- Note that the pre-connected plug will be connected to

the Sonar Interface Unit in the wheelhouse at a later

stage.

Note: The data cable from the wheelhouse to the sonar room must be

supported and protected along its entire length using conduit

and/or cable trays. The cable must not be installed in close

proximity to high-power cables antenna cables or other possible

sources of interference.

This cable must not be spliced. If it is not long enough, or if an

accident occurs to it, contact your local dealer or Simrad for

advice.

2 Do not

connect the plug to the Sonar Interface Unit.

References

→ Cable termination details (W208D), page 193

→ Transceiver Unit connection, page 78