Installation manual

Simrad SP90
72
851-164510 / Rev.E
C7 - Operating panel (USB)
This is a standard USB data cable. It connects between the
Sonar Operating Panel and the Sonar Processor Unit. The cable
is included in the standard delivery, and the cable length is 4,5
meters. The cable has a quadratic USB connector in the Sonar
Operating Panel end, and rectangular USB connector in the
Sonar Processor Unit end. Observe the following procedure for
the connection of the USB data cable.
1 Connect the quadratic USB connector to the Operating
Panel.
2 Connect the rectangular USB connector to the lowest USB
connector on the rear left hand side of the Sonar Processor
Unit.
Figure 18 Connections to
the rear side of the SP90
Sonar Operating Panel
3 Secure the USB connector and cable with a plastic strip
(A) and the self-adhesive support plate already provided.
Figure 19 Securing the USB
cable and connector.
References
→ Operating Panel connections, page 72
→ Sonar Processing Unit connections, page 68
→ Cable termination details (W501), page 200