Installation manual

Cable layout
69
851-164510 / Rev.E
Cables
C1 - AC Power to the Display Unit
This is a standard mains supply cable. It is included in the
delivery with the optional Simrad display units. The mains
voltage for the Simrad LCD monitors is 115 or 230 Vac, and
they will automatically sense the current supply voltage. For
other type of displays, refer to the applicable documentation.
Observe the following procedure for the connection of the
mains supply to the display unit.
1 Connect the mains supply cable between the mains
connector at the rear side of the display unit and a normal
mains outlet.
If the delivered cable connector does not fit, replace it with a
suitable connector.
References
→ Cable termination details (W301), page 196
C2 - Display cable
This is a standard display cable, where VGA (or DVI) signal
outputs may be used. The cable is normally attached to the
display, and terminated in the computer end with a male 15-pin
Delta connector (VGA) or a special DVI connector. The cable is
normally supplied by the display manufacturer.
Observe the following procedure for the connection of the
display unit to the Sonar Processor Unit.
1 Connect the display cable to the appropriate connector on
the circuit board in slot J1.
The circuit board in slot J1 in the computer provides two Delta
connectors. The top connector is for VGA, while the bottom is
for DVI.
References
→ Cable termination details (W500), page 199