Installation manual

Simrad SP90
IV
851-164510 / Rev.E
6.5 Sonar Processor Unit (MC70) 57................................
6.6 Sonar Interface Unit 58.......................................
6.7 Loudspeaker 59.............................................
7 CABLE LAYOUT 60..........................................
7.1 Introduction 60..............................................
7.2 System cabling 61...........................................
7.3 SP90 Cable plan 62..........................................
7.4 Cable specifications 64.......................................
7.5 Wheelhouse cabling 67.......................................
7.6 Sonar room cabling 75........................................
7.7 Cable details 83.............................................
7.8 Basic cabling requirements 84..................................
8 PERIPHERAL EQUIPMENT 87...............................
8.1 General 87.................................................
8.2 Speed log connection 89......................................
8.3 Course gyro connection 91....................................
8.4 (D)GPS connection 92........................................
8.5 Echo sounder connection 93...................................
8.6 Trawl system connection 94....................................
8.7 Catch monitoring system connection 95..........................
8.8 Current meter 96............................................
8.9 Radio buoys 97..............................................
8.10 Trackball / mouse connection 98................................
9 START-UP PROCEDURES 99................................
9.1 Introduction 99..............................................
9.2 Check--list before start--up commences 100.........................
9.3 Starting up the stand--by power supply 101.........................
9.4 Starting up the Hull Unit 103....................................
9.5 Starting up the wheelhouse units 109.............................
9.6 Checking the Operating Panel 111...............................
9.7 Checking the hoisting/lower system 117...........................
9.8 Starting up the Transceiver Unit 123..............................
9.9 Self--noise test 125............................................
9.10 System start--up 126...........................................
9.11 Alignment of the sonar picture 130...............................
9.12 Adjusting the stabilisation sensor offset 132........................
9.13 Setting own ship parameters 134.................................