Installation manual

Simrad SP90
66
851-164510 / Rev.E
SP90/C17 Motor control
This cable is connected between the Transceiver Unit and the
Motor Control Unit mounted on the Hull Unit. Note that the
physical properties of this cable is identical to those of C15.
Therefore, any surplus of the C15 cable can be used.
→ Cable details on page 195
SP90/C18 AC mains to Transceiver Unit
This is a standard AC mains cable. It is provided by Simrad.
→ Cable details on page 196
SP90/C19 - Motor control mains
This cable provides AC mains to the Motor Control Unit. The
cable must be provided by the installation shipyard.
→ Cable details on page 197
SP90/C20/C21/C22/C23 Serial lines
These are cables used to interface peripheral equipment. They
are described in detail in chapter Peripheral equipment.
→ Peripheral equipment, page 87
SP90/C24 Scientific interface
This is an optional ethernet connection.
→ Cable details on page 198
SP90/C25 Synchronization
This interface allows the sonar transmissions to be synchronized
by an external system. It also allows the sonar to be “master” in
a synchronized system.
→ Cable details on page 194