Installation manual

Cable layout
65
851-164510 / Rev.E
SP90/C7 Operating panel (USB)
This is a standard USB data cable used between the Sonar
Processor Unit and the Operator Panel. It is provided by Simrad.
→ Cable details on page 200.
SP90/C8 Keyboard A
This is a special “dual” cable. It is used from the Operating
Panel (where it plugs into a common socket) to both the Sonar
Processor Unit and the Sonar Interface Unit. The cable is
provided by Simrad.
→ Cable details on page 201.
SP90/C9 Keyboard B
This is a special “dual” cable. It is used from the Operating
Panel (where it plugs into a common socket) to both the Sonar
Processor Unit and the Sonar Interface Unit. The cable is
provided by Simrad.
→ Cable details on page 201.
SP90/C10 Loudspeaker
This is a special cable for connections between the loudspeaker
and the Sonar Interface Unit. The cable is physically connected
to the speaker, and thus provided by Simrad.
→ Cable details on page 190
SP90/C11 Pulse speed log
The pulse speed log is connected to the Sonar Interface Unit.
Note that a speed log can also be connected using an RS-232
serial line. This is described in detail in chapter Peripheral
equipment.
→ Peripheral equipment, page 87
SP90/C12/C13/C14 Serial lines
These are cables used to interface peripheral equipment. They
are described in detail in chapter Peripheral equipment.
→ Peripheral equipment, page 87
SP90/C15 Transceiver Unit
This is a data cable from the Sonar Interface Unit in the
wheelhouse to the Transceiver Unit in the sonar room. The cable
is provided by Simrad.
→ Cable details on page 193
SP90/C16 Transducer cable
The transducer cables are physically connected to the top of the
transducer shaft. All transducer cables are provided by Simrad.