Installation manual

Simrad SP90
64
851-164510 / Rev.E
7.4 Cable specifications
The list below specifies each cable used on the SP90 sonar.
References are made to detailed cable drawings and
specifications.
Note that the Sonar Processor Unit provides a large number of
connectors that are not used by the SP90 sonar. Those
connectors are left out of the list below.
Installation procedures for the wheelhouse cables, sonar room
cables and peripherals are provided as follows:
→ Wheelhouse cabling, page 67
→ Sonar room cabling, page 75
→ Peripherals, page 87
SP90/C1 AC mains to display monitor
This is a standard AC mains cable. It is provided by the display
manufacturer.
→ Cable details on page 196
SP90/C2 Display (video signal)
This is a standard commercial VGA or DVI display cable. It is
provided by the display manufacturer.
→ VGA Cable details on page 199
SP90/C3 AC mains to Sonar Processor Unit
This is a standard AC mains cable. It is provided by Simrad.
→ Cable details on page 196
SP90/C4 Sonar Interface Unit control
This is a special control cable used between the Sonar Processor
Unit and the Sonar Interface Unit. It is provided by Simrad
preconnected to the Sonar Interface Unit.
→ Cable details on page 188
SP90/C5 Sonar Interface Unit serial
This is a special serial cable used between the Sonar Processor
Unit and the Sonar Interface Unit. It is provided by Simrad
preconnected to the Sonar Interface Unit.
→ Cable details on page 188
SP90/C6 Sonar Interface Unit cheapernet
This is a special cheapernet coaxial cable used between the
Sonar Processor Unit and the Sonar Interface Unit. It is
provided by Simrad.
→ Cable details on page 189