Installation manual

Installation manual
III
851-164510 / Rev.E
1 INTRODUCTION 1.........................................
1.1 The purpose of this manual 1..................................
1.2 System diagram 2...........................................
1.3 Scope of supply 4...........................................
1.4 Peripheral equipment 7......................................
1.5 Supply conditions 9.........................................
1.6 General safety rules 10........................................
1.7 General installation requirements 11.............................
1.8 Equipment handling 13.......................................
2 INSTALLATION PLANNING 24.............................
2.1 Introduction 24..............................................
2.2 Location of the Hull Unit 25...................................
2.3 Sonar room requirements 27...................................
3SONARTRUNK 31...........................................
3.1 Introduction 31..............................................
3.2 Mounting the trunk 32........................................
3.3 Protection 33...............................................
3.4 Principles 34................................................
3.5 Trunk installation measurements 37.............................
4HULLUNIT 38...............................................
4.1 Introduction 38..............................................
4.2 Hull unit models 39..........................................
4.3 Unpacking 40...............................................
4.4 Mounting 41................................................
4.5 Bleeding air 42..............................................
4.6 Mechanical support 43........................................
4.7 Transducer alignment 44......................................
4.8 Installation check--list 45......................................
5 TRANSCEIVER UNIT 46.....................................
5.1 Introduction 46..............................................
5.2 Installation procedure 47......................................
5.3 Transceiver Unit drawings 48..................................
6 WHEELHOUSE UNITS 51....................................
6.1 Introduction 51..............................................
6.2 Location 52................................................
6.3 Display unit 55..............................................
6.4 Sonar Operating Panel 56.....................................