Installation manual

Wheelhouse units

851-164510 / Rev.E

6.5 Sonar Processor Unit (MC70)

The MC70 Sonar Processor Unit should be mounted on the deck

or shelf inside a console, cabinet or desk. It must be mounted

close to the Sonar Interface Unit, Operating Panel and display

unit.

Provide enough space for easy access to the cabling at the rear

of the unit and for removal of the front lid.

Figure 13 Mounting

the Sonar Processor

Unit.

(CD7006C)

Computer assembly

Mounting frame

with shock absorbers

Fastening screwsLocking pin

Observe the following procedure. To ensure correct operation,

tick off every item when the action has been carried out.

1 Prepare the mounting location.

2 Dismount the mounting frame with the shock absorbers

from the Sonar Processor Unit by loosening the two

fastening screws on the front, and pull the computer

assembly forwards.

3 Place and secure the mounting frame with six bolts or

screws to the basement. The diameter of the holes are 7

mm.

4 Reattach the Sonar Processor Unit to the mounting frame

by guiding it backwards until the locking pins at the

bottom of the computer assembly find the correct

positions. Secure the assembly with the two fastening

screws on the front.