Installation manual

Simrad SP90

851-164510 / Rev.E

6.4 Sonar Operating Panel

Observe the following procedure. To ensure correct operation,

tick off every item when the action has been carried out.

1 Mount the Sonar Operating Panel in an almost horizontal

position to facilitate operation of the trackball.

- The necessary mounting hardware (four screws, four

nut plates and four bolt covers) are supplied in the

standard delivery.

2 Drill and cut the panel opening as shown in the figure.

3 Mount the Sonar Operating Panel using the supplied

hardware.

a Position the four nut plates shown in the figure.

b Use a 3 mm Allen key to fasten the four special bolts.

c Mount the bolt covers in the four corners of the

Operating Panel.

Figure 12 Operating panel cut-out