Installation manual

Transceiver unit
47
851-164510 / Rev.E
5.2 Installation procedure
Observe the following procedure. To ensure correct operation,
tick off every item when the action has been carried out.
1 Remove the two mounting brackets which are fastened to
the shock absorbers on the Transceiver Unit.
- Use the Allen key found in the plastic bag fastened to
the upper shock absorber.
2 Weld the mounting brackets securely to the bulkhead.
3 Use a chain fall or similar device to lift the Transceiver
Unit into position and bolt it to the mounting brackets.
- Note that eight bolts are provided in the plastic bag
fastened to the upper shock absorber.
4 Connect the grounding cable from the Transceiver Unit to
the mounting bracket.