Installation manual

Simrad SP90
46
851-164510 / Rev.E
5 TRANSCEIVER UNIT
5.1 Introduction
Note: The Transceiver Unit must be mounted as a complete unit. The
door must not be opened until the unit is securely fastened to the
bulkhead.
Before mounting the Transceiver Unit, observe that the distance
between the Hull Unit and the Transceiver Unit is restricted by
the flexible transducer cable joining the two. Remember to take
into consideration the slack necessary to lower the transducer.
Caution: Do not fasten the transducer cable to the Transceiver
Unit until described later in the start-up procedure.
Free bulkhead space is required to mount the Transceiver Unit
cabinet.
Topics
→ Procedure, page 47
→ Drawings, page 48