Installation manual

Installation manual

851-164510 / Rev.E

Sections

1Introduction

This section provides a generalk introduction to the sonar installation. Refer

to page 1.

2 Installation planning

This section explains how the installation is planned, and which parameters

need considering. Refer to page 24.

3 Installation of the Sonar Trunk

This section explains how to manufacture and install the sonar trunk. Refer to

page 31.

4 Installation of the Hull Unit

This section explains how to install the hull unit gantry on top of the sonar

trunk. Refer to page 38.

5 Installation of the Transceiver Unit

This section explains how to install the Transceiver Unit electronic cabinet.

Refer to page 46.

6 Installation of Wheelhouse Units

This section explains how to install the wheelhouse units; computer, display

and interface unit. Refer to page 51.

7 Cable layout

This section details all cabling. Refer to page 60.

8 Connecting auxiliary equipment

This section explains how to connect external equipment, such as motion and

positioning sensors. Refer to page 87.

9 Start-up procedures

This section explains how to start up the sonar for the first time. Refer to page

99.

10 Testing the peripheral equipment

This section explains how to test the external peripherals, and to make sure that

the data are accepted by the sonar. Refer to page 136.

11 Final testing and measurements

This section explains how to perform t he final performance tests. Refer to page

150.