Installation manual

Introduction

851-164510 / Rev.E

Storage

Pre-installation storage

The equipment should be stored in its original transportation

crate until ready for installation. The crate must not be used for

any purpose for which it was not intended (eg. work platform

etc.).

Once unpacked, the equipment must be kept in a dry, non

condensing atmosphere, free from corrosive agents and isolated

from sources of vibration.

Note: Do not break the seal to open a circuit board package before the

board is to be used. If the board package is returned to the

manufacturers with the seal broken, the contents will be

assumed to have been used and the customer will be billed

accordingly.

The unit must be installed in its intended operating position as

soon as possible after unpacking.

If the unit contains normal batteries, these may have been

disconnected/isolated before the unit was packed. These must

then be reconnected during the installation procedure. Units

containing batteries are marked.

Caution: Units containing lithium or alkaline batteries must be

handled separately and with care. Such units are

marked accordingly. Do not attempt to recharge such

batteries, open them or dispose of them by

incineration. Refer to the applicable product data

sheets.

After use storage

Introduction

If a unit is removed from its operating location and placed into

storage, it must be properly cleaned and prepared before

packing.

Cleaning cabinets

If a cabinet has been exposed to salt atmosphere while it was in

use, it must be thoroughly cleaned both internally and externally

to prevent corrosion.