Installation manual

Testing the peripheral equipment
149
851-164510 / Rev.E
10.10 Current meter system
Observe the following procedure to test the Current Meter
system interface.
1 Access the I/O Setup menu.
→ A procedure f or this is located on page 137.
2 Select Sensors in the I/O Setup menu, then Current
meter, and finally Kaijo.
3 Observe the Sensor Config submenu appears at the
bottom of the menu field.
4 Check that the settings in the Sensor Config submenu
correspond to your requirements for the serial line.
5 Press Close to exit the Sensor Config menu.
6 Select the Objects menu, and check that the Buoy readout
(F) is shown.
7 Select one of the buoys in the Objects menu, and verify
that the buoy data is shown in the dialogue below the
menu.