Installation manual

Testing the peripheral equipment

143

851-164510 / Rev.E

Heading data from (D)GPS

If the GPS is used for the course gyro input, wait with this test

until the GPS position data are tested.

Use the following procedure for testing the GPS input:

1 Access the I/O Setup menu.

2 Select Sensors in the I/O Setup menu, then Heading and

finally Gyro.

3 Observe the Sensor Config submenu appears at the

bottom of the menu field.

4 Change the settings in the Sensor Config submenu to suit

your requirements for the serial line.

5 Press Close to exit the Sensor Config menu.

6 Check that the heading readout in the Status menu

corresponds to the GPS heading.