Installation manual

Start-up procedures
135
851-164510 / Rev.E
Observe the following procedure for transducer and GPS
antenna positioning.
1 Ensure that the Installation menu is visible at the top of
the sonar display.
- If not, refer to the first procedure in this chapter.
2 Select Own Ship on the Installation menu, then
Inst rument Position Offsets, and finally Transducer.
3 Observe the Instrument Offset Positions menu appear at
the bottom of the menu field.
4 Press the X P osition button and enter the correct value.
5 Press the Y P osition button and enter the correct value.
6 Press Close to finish.
7 Select Own Ship on the Installation menu, then
Inst rument Position Offsets, and finally GPS.
8 Observe the Instrument Offset Positions menu appear at
the bottom of the menu field.
9 Press the X P osition button and enter the correct value.
10 Press the Y Position button and enter the correct value.
11 Press Close to finish.
When a new display mode is selected, the instruments will
change to the chosen positions.