Installation manual

Start-up procedures
133
851-164510 / Rev.E
Procedure: To enter the stabilisation
offset angle
Observe the following procedure to enter the offset stabilization
angle as a parameter into the sonar system.
1 Select the Setup menu
2 Press the Test... to bring up the System test menu.
3 Press the Installation Menu button, and observe the menu
appears on the top of the display.
4 Select Installation on the Installation menu,andthen
Alignment.
5 Observe the Sonar transceiver configuration menu
appear at the bottom of the menu field.
6 Press the Offset button.
7 Enter the estimated offset angle.