Installation manual

Start-up procedures
99
851-164510 / Rev.E
9 START-UP PROCEDURES
9.1 Introduction
The procedures in this chapter shall be carried out once all the
hardware units have been installed, and the cabling is finished.
When you perform the procedures, make sure that you only
perform those tasks described, and in the given order. Also,
check off every item in the procedure as you carry on.
Procedures
→ Checklist before start-up commences, page 100
→ Staring the stand-by power supply, page 101
→ Staring up the Hull Unit, page 103
→ Starting the wheelhouse units, page 109
→ Checking the Operator Panel, page 111
→ Checking the hoisting and lowering system, page 117
→ Starting up the Transceiver Unit, page 123
→ Self-noise test, page 125
→ System startup, page 126.
→ Alignment of the sonar picture, page 130
→ Alignment of the stabilization offset, page 132
→ Defining own ship parameters, page 134