Specifications

Installation | 7
2 Installation
Location of the unit
The RPM70/RPM80 and SP70/SP80 instruments
should be mounted with special regard to the unit’s
environmental protection, temperature range and cable
length. Refer to the Specifications chapter.
Avoid mounting the unit where it is easily exposed to
sunlight, as this may unintendedly overheat the unit.
For RPM70 and SP70 a weather cover is included and the
cover should be put on when the unit is not in use.
Panel mounting
The mounting surface must be at and even to within
0.5 mm.
Drill 4 mounting holes and make a panel cut-out 1
according to the drilling template included in the
package
Use the supplied self tapping screws to secure the 2
unit to the panel
Apply the front corners3
Do not over-tighten the screws!
