Specifications

Operation | 11
3 Operation
Turning indicators on
The indicators have no power key, and will be running as
long as power is applied.
When power is applied to the system the instrument will
operate in the main mode.
After approximately 3 seconds the instrument is
operative.
Before the instrument is ready to operate the default
settings should be checked and changed if other values
are preferred. Refer to the Changing the default settings
chapter.
Using the keys
The instrument is operated by the 2 keys on the front.
They are used to switch between display modes, to set
values and to adjust the illumination as illustrated in the
table below.
Key presses or key combinations not indicated in the
table have no effect.
Refer also to Operation flow chart.
KEY
KEY
PRESS
MODE/ACTION
DISPLAY MODE SETUP MODES
MODE
SETUP
3 sec. Switch to User Setup Switch to main display
SELECT
Short Increase light level
Select parameter
Adjust parameter
MODE
SETUP
+
SELECT
Short
Save setting and return to
Setup parameter
10 sec.
Enter Installation
Setup
5 sec Return to main display
Time out from User Setup is 10 sec. Time out from
Installation Setup is 5 min.
