Installation manual

Connecting peripher al equipment
75
851-164574 / C
8 PERIPHERAL EQUIPMENT
8.1 General
Introduction
It is not necessary to make the connection of the peripheral
equipment before the start-up procedure is finished, and this
equipment may therefore be connected later.
However, do not connect the termination plugs for the auxiliary
equipment to the Sonar Interface Unit before mentioned in a later
chapter.
Required inputs
The SP60 sonar system requires input from both a speed log and
a course gyro. Inaccurate data from either of these instruments
will result in an incorrect indication of vessel and target
movements.
→ Speed log, page 77.
→ Course gyro, page 79.
Additional inputs
The following peripheral sensors may be connected to the SP60
sonar:
→ (D)GPS, page 80.
→ Echo sounder, page 81.
→ Trawl System, page 82.
→ Purse seine system, page 83.
→ Current meter system, page 84.
→ Radio buoy system, page 85.
→ Trackball and mouse, page 86.