Installation manual

Cable layout and connections
71
851-164574 / C
2 Set the mains voltage selector switch S201 on the Power
Supply and S203 on the HV Power Unit to correspond to the
correct mains voltage (115 Vac or 230 Vac).
3 Set the service switch S202 on the Power Supply to the Off
(middle) position.
4 Connect the mains power cable to a normal mains outlet in
the sonar room.
- If the delivered cable connector does not fit use an
adaptor, or replace with a suitable plug.
→ For connection of t he mains cable, refer to figure 22 on page 66.
C16 - Transducer cable
The transducer cables are provided by the manufacturer. They are
physically connected to the top of the transducer shaft.
Caution Do not mount the flexible t ransducer cable to the Transceiver
Unit.