Installation manual

Simrad SP60

851-164574 / C

7.5 Sonar room cabling

Introduction

All sonar room cabling must be performed as specified. The cable

numbers used to identify the cables in the figures and following

procedures are identical to those used in the cable plan and cable

overview table.

(CD5700A)

C17 C15 C18

Live Neutral

Ground

Figure 22

Transceiver Unit cable

connections

Note Due to the flexible shock mounting, all cables connected to the

Transceiver Unit must have appropriate slack to allow for

approximately 10 cm cabinet movement in all directions.

Cables

C17 - Motor control

This cable is connected between the Transceiver Unit and the

Motor Control Unit mounted on the Hull Unit. Use the surplus of

cable C15, or an equivalent type of cable.

→ Refer to page 180 for detailed information about the cable and the

connections to be made.

Observe the following procedure. To ensure correct operation, tick

off every item when the action has been carried out.

1 Use the cable gland on the left-hand side of the Transceiver

Unit.

→ The bottom of t he Transceiver Unit is shown in figure 22.