Installation manual

Simrad SP60

851-164574 / C

2 INSTALLATION PLANNING 22.............................

2.1 General 22.................................................

2.2 Location of the Hull Unit 23...................................

Fore and aft 23.............................................

Athwartships 23............................................

Important considerations 23...................................

2.3 Sonar room requirements 25...................................

Size 25...................................................

Access hatches 25...........................................

Lifting 25.................................................

Heating 25................................................

Insulation 25...............................................

Ventilation 25..............................................

Conduit 26................................................

Air vent pipe 26............................................

Bilge pump 26.............................................

Lighting 26................................................

Dry docking 26.............................................

Decking 26................................................

3SONARTRUNK 29...........................................

3.1 Mounting of the trunk 29......................................

3.2 Protection 30...............................................

Protecting blister 30.........................................

Corrosion protection 30......................................

3.3 Trunk installation measurements 30.............................

3.4 Principles 31................................................

4HULLUNIT 34...............................................

4.1 Introduction 34..............................................

4.2 Hull unit models 35..........................................

4.3 Unpacking 36...............................................

4.4 Mounting 37................................................

4.5 Bleeding air 38..............................................

4.6 Mechanical support 39........................................

4.7 Transducer alignment 40......................................

4.8 Installation check--list 41......................................

5 TRANSCEIVER UNIT 42.....................................

Introduction 42.............................................

Procedure 42...............................................