Installation manual

Simrad SP60
58
851-164574 / C
7.3 Cable specifications
The list below specifies each cable used on the SP60 sonar.
References are made to detailed cable drawings.
Note that the Sonar Processor Unit provides a large number of
connectors that are not used by the SP60 sonar. Those connector s
are left out of the list below.
Installation procedures for the wheelhouse cables, sonar room
cables and peripherals are provided as follows:
→ Wheelhouse cabling, page 60.
→ Sonar room cabling, page 66.
→ Peripherals, page 75.
C1 / C3 / C18 - AC Mains
These are standard AC mains cables. The computer and transceiver
cables are supplied by Simrad, the display cable is provided by the
display manufacturer.
→ Cable details on page 181.
C2 - Display
This is a standard VGA or DVI display cable. It is normally
provided by the display manufacturer.
→ VGA Cable details on page 184.
C4 / C5 / C6 - Sonar Interface Unit
This are the control and signal cables between the Sonar Processor
Unit and the Sonar Interface Unit. The cables are provided by
Simrad.
→ Cable details on page 173.
C7
- Operating panel (USB)
This is a standard USB data cable. It is provided by Simrad.
→ Cable details on page 185.
C8 / C9 - Operating panel (Power and serial)
This is a special dual cable from the Operating Panel to the Sonar
Processor Unit and the Sonar Interface Unit. T h e cable is provided
by Simrad.
→ Cable details on page 186.
C10 - Loudspeaker
This is a special cable for connections between the loudspeaker and
the Sonar Interface Unit. The cable is physically connected to the
speaker, and thus provided by Simrad.
→ Cable details on page 175.