Installation manual

Simrad SP60
48
851-164574 / C
Display unit
The display unit should be located so that it is best protected from
glare which reduces readability. I t may be:
• Panel mounted
• Desktop mounted
• Bulkhead mounted
• Overhead mounted
Refer to the display unit’s i nstruction manual for the compass safe
distance.
Sonar Operating Panel
An ergonomiclly correct Operating Panel helps to reduce operator
fatigue. It should be mounted in a nearly horizontal position to
facilitate trackball operation, and within easy viewing range of the
display unit.
The compass safe distance must be allowed for when planning the
unit’s location:
• Standard compass 0.05 m.
• Steering compass 0.05 m.
SonarProcessorUnit
The Sonar Processor Unit (MC70) should be installed inside a
console, in a cabinet or on a desk. Make sure that adequate
ventilation is available to avoid overheating.
The compass safe distance must be allowed for when planning the
unit’s location:
• Standard compass 0.15 m.
• Steering Compass 0.1 m.
Sonar Interface Unit
The Sonar Interface Unit should be mounted vertically with the
cable inlet downwords on a side wall inside a console, cabinet or
desk. Provide enough space for easy access for cable connections
to the unit.
The compass safe distance must be allowed for when planning the
Sonar Interface Unit’s location:
• Standard compass TBD m.
• Steering Compass TBD m.