Installation manual

Simrad SP60
114
851-164574 / C
Starting up the transmitter
The following set of procedures requires two persons. One person
must be stationed on the bridge to oper ate the sonar, while one must
stay in the sonar room to make sure the Transceiver Unit works
properly.
Make sure that proper communication exists between the two
locations.
Note Should problems occur i n the sonar room, the person in the sonar
room must set the service switch S202 to Off.
The following two procedures must be performed simultanously
by the person on the bridge and t he person in the sonar room.
To simplify the test, remove the applicable pages from this manual.
Figure 38 Location of the
COM and TXEN LE Ds