Installation manual

Installation manual
VII
851-164574 / C
9.13 Setting own ship parameters 122.................................
Ship dimensions 122.........................................
Instrument position offsets 122.................................
10 TESTING THE PERIPHERAL EQUIPMENT 124...............
10.1 Introduction 124..............................................
10.2 General 125.................................................
Default interface settings 125...................................
Changing the interface settings 125..............................
Serial line inspection 126......................................
10.3 Speed log 128................................................
Introduction 128.............................................
Pulse log (200 pulses per nautical mile) 128.......................
Speed log with RS-232 serial line 128............................
Speed data from (D)GPS 129...................................
10.4 Course gyro 130..............................................
Introduction 130.............................................
Course gyro 130.............................................
Heading data from (D)GPS 130.................................
10.5 (D)GPS 132.................................................
10.6 Echo sounder 133.............................................
10.7 Trawl system 134.............................................
10.8 Purse seine system 135........................................
10.9 Radio buoy system 136........................................
10.10Current meter system 137......................................
11 FINAL TESTS AND MEASUREMENTS 138....................
11.1 Intr oduction 138..............................................
11.2 Source level (SL) measurements 139.............................
Preparations 139.............................................
Preparing the operational mode 139.............................
Test procedure 139...........................................
Measurement termination 142..................................
11.3 Receiving voltage response (VR) 143.............................
Preparations 143.............................................
Procedure 143...............................................
Measurement termination 145..................................
11.4 Noise/speed curve 146.........................................
Preparations 146.............................................
Procedure 146...............................................