Installation manual

Simrad SP60
88
851-164574 / C
9.2 Check-list before start-up commences
Before you commence with the start-up procedure, check the
following items. To ensure correct operation, tick off every item
when the action has been carried out.
Processor Unit
1 Check that the connector on cable C15 from the Transceiver
Unit is disconnected from the Sonar Interface Unit in the
wheelhouse.
J3 connector for C1
5
(CD7011)
Figure 29 C15 connects to socket
J3 in the Sonar Interface Unit
Transceiver Unit
2 Check that the ship’s mains fuses to the Transceiver Unit are
disconnected.
3 Check that the mains input connector P201 on the power
supply in the Transceiver Unit is disconnected.
→ Refer to figure 30 on page 89.
4 Check that the transducer plug is not connected to the
left-hand side of the Transceiver Unit.
Hull Unit
5 Check that the ship’s mains fuses to the Hull Unit are
disconnected.