Installation manual

Simrad SP60

851-164574 / C

8.8 Current meter 84............................................

8.9 Radio buoys 85..............................................

8.10 Trackball / mouse connection 86................................

9 START-UP PROCEDURES 87................................

9.1 Introduction 87..............................................

9.2 Check--list before start--up commences 88.........................

9.3 Starting up the stand--by power supply 89.........................

9.4 Starting up the Hull Unit 91....................................

Introduction 91.............................................

Functional check 91.........................................

Apply 3-phase AC power 93..................................

Re-wire for 230 Vac 3-phase 94................................

Functional check with power 95...............................

9.5 Starting up the Wheelhouse Units 97.............................

Introduction 97.............................................

Start up 97................................................

Display set-up 98...........................................

9.6 Checking the Operating Panel 99...............................

Introduction 99.............................................

Functional test 99...........................................

Power off 103...............................................

9.7 Checking the hoisting/lower system 104...........................

Introduction 104.............................................

Preparations 104.............................................

Checking the bridge functions 105..............................

Checking the sonar room functions 109..........................

9.8 Starting up the Transceiver Unit 110..............................

9.9 Self--noise test 112............................................

9.10 System start--up 113...........................................

Introduction 113.............................................

Preparations 113.............................................

Starting up the transmitter 114..................................

Actions on the bridge 115.....................................

Actions in the sonar room 117..................................

9.11 Alignment of the sonar picture 118...............................

9.12 Adjusting the stabilisation sensor offset 120........................

Procedure: To estimate the offset angle 120.......................

Procedure: To enter the stabilisation offset angle 121................