Specifications

Setting-Up
20220752J 31
6 SETTING-UP
6.1 First Time Turn on
Note ! Always turn on all NMEA “listeners” and “talkers” connected
to the system before the first time you turn on the IS15 system.
This includes turn on after a COMMUNICATION RESET or a
MASTER RESET. The system will then automatically configure
the IS15 NMEA ports as talkers or listeners.
Before leaving the factory a Master Reset has been performed on
all the instruments. The first time power is applied to a Wind or
Tack instrument, the display will read:
1.6
(software version ) and then
PrES
To assign an instrument to a system, press the
button. In a
multiple instrument system the instruments are assigned to the
system and given an Id number in the same sequence as the
buttons are pressed. The instrument that is assigned as #1 will be
the master unit and broadcast common set-up information on the
Roblink to the other instruments.
Id:1
Notes !
1. In a system with mixed software always start assigning the
ones with the latest software version.
2. When assigning more than one instrument to a system, allow
a few seconds interval between each assignment, while the
display is showing:
–
– –
3. When an instrument is replaced it is important that a Master
Reset has been made on the new one before it is connected to
the system. Refer to Local Master Reset on page 41.
After having assigned all instruments, turn the system off and
then on (the instruments will display P.OFF if you forget). The
pointer will make a 360° turn and then the instrument will
display apparent wind.