Specifications

IS15 Wind Manual
22 20220752J
6. When the wand is correctly in position,
screw down the collar until it is HAND tight
(2).
7. Lock the retaining clip into place (3).
Note !
Remove the wand in the reverse order.
8. The cable is easily threaded down the mast if a pull-through
cord or mouse has been left for that purpose. If there is no
mouse, it may help to fix a weight to the end of the cable to
assist its passage through the mast.
9. If there is a small error in the alignment of the masthead unit,
this can be compensated for. Please refer to the relevant
calibration instructions for more details.
Note ! The masthead bracket includes an integral weatherproof cap
that should always be fitted to the socket if the wand has been
removed.
5.4 Cabling
Stand Alone system (W-1)
Wind
Transducer
IS15 Wind
SIMR AD
Junction box (mast foot)
Supply 10,8-15,6VDC
10m (33')
30m (99')
Speed/heading
input on NMEA
Circuit
breaker
*
**
Roblink cable with connector
(Special) Roblink Power Cable
*
**
Fuse
1A Slow
+
Figure 5-3 W-1 IS15 Wind System