Specifications

IS15 General Manual
48 20220760L
If you want to change the set course apply short presses on the
or button to set the next course to steer to port or
starboard respectively.
Press and hold the
button for 2 seconds to enter the new
setting.
The display will stop flashing and the arrow points in the
direction to steer, while the digits on the LCD show how much
the boat is off the new set course.
4.5 Alarm Sounding
The alarm is system wide and all the instruments will sound and
flash a warning message.
If there is an external alarm connected then this will be sounded
at the same time (only if an IS15 Expander is part of the system).
To cancel a sounding alarm press any button on any of the
instrument displays.
Note ! The flashing warning will remain as long as the alarm condition
exists and disappears automatically when there is no longer an
alarm condition. The sounding alarm will always have to be
cancelled.
Alarm messages
The symbols that are shown when an alarm is triggered are as
below:
‘SHAL’ = The Shallow Water Alarm
‘dEEP’ = The Deep Water Alarm
‘AnCH’ = The Anchor Alarm
‘HIGH’ = The High Wind Speed Alarm
‘Er.XX’ = System failure (Contact your Simrad dealer)
Compass calibration:
‘RUn.C’ = Compass calibration running
‘FAIL’ = Compass calibration failed
‘dOnE’ = Compass calibration done