Specifications

Setting-Up
20220760L 105
2. When the Roblink has been turned Off it will not default to
ON even after a Master Reset. If required it must therefore
be turned On again using the procedure above.
Screen 8
ROBLINK TEST [tESt]
Refer to section 8 Fault Finding for details.
Screen 9
COMMUNICATION RESET [C.rES]
Allows you to reset the system communication (Roblink) in the
event anomalies are observed on one or more instruments. This
reset will not default the calibration or settings.
Press the
button and hold for 2 seconds. The LCD display
shows ‘P.OFF’. Turn the system off, refer to the beginning of
this section and assign the instrument(s) to the system.
Screen 10
MASTER RESET [rES]
When a MASTER RESET is performed on one of the
instruments in a system it becomes system wide and all
instruments are reset to default values.
Note ! Do not perform a Master Reset unintentionally because it will
default settings and calibration values.
Press the
button and hold for 2 seconds. The LCD display
shows ‘P.OFF’. Turn the system off, refer to the beginning of
this section and assign the instrument(s) to the system.
Note ! After the Master Reset a new set-up has to be performed.