Installation manual

Simrad SH80
Print: Click this button to print a selected file on either the
temporary or permanent list.
System Test menu
The System test menu is activated by the
Test button in the Setup menu. (► Setup
menu on page 84). This menu provides
several sensor measurements and test
functions for operational and functional
tests. Note that tests are designed only
to be carried out by qualified ser vice
engineers. From this menu you can also
access the
Message Bar configuration.
Buttons
Test Config(uration): This function is only to be activated by
qualified service engineers.
Toggle T X Power On/Off: T his button allows you to switch the
transmit power on and off. This function is only to be used
during system t esting.
Test beam: This function is only to be activated by qualified
service engineers.
Roll: This button provides a read-out from the roll sensor. It
presents the actual roll value at the time of the last transmission.
Pitch: T his button provides a read-out from the pitch sensor. It
presents the actual pitch value at the time of the last transmission.
TRU Temp: This button provides a read-out of the current
temperature inside the Transceiver Unit. If the temperature rises
to an unacceptable level, an alarm will be given. The i nformation
will only be valid if the transceiver has been equipped with the
relevant sensor.
90
164385/E