Installation manual

Menu descriptions
Movements: This function makes it possible to estimate the
position of a tracked school at a given time. (► Movements on
page 133)
Track window: This command enables you to adjust the size
of the window the sonar places on the chosen target. A larger
track window will enable the system to track a large target more
easily, but the system will be more susceptible to background
noise. Smaller targets may be ignored if there is a lot o f noise in
the area, as the system will track the strongest echo within the
track window.
Wind direction: The wind marker is show in the outer area
of the echo presentation as a white arrow. This arrow can be
manually adjusted for indication of the wind or current direction,
or automatically show the wind direction if a wind sensor is
connected.
Wind speed: This is not a parameter. It is only a read-out of the
current wind speed providing that a wind sensor is c onnected.
Sort modes: Click to access the Sort Modes temporary m enu.
This menu is used to select the display modes to be activated by
the four
Mode buttons on the Operating Panel. The four upper
display modes in the
Sort Modes menu will always be the four
modes activated by the four
Mode buttons in the order they are
sorted. (► Sort Modes menu on page 91)
External sync(hronisation): This function makes it possible
to eliminate interference from other Simrad sonars on board
your vessel. If the sonars are connected together, you can use
these settings to synchronise their transmissions. (► External
Synchronisation on page 120)
Scientific O utput: This is an optional functionality designed to
be used when the sonar is used for scienti fic purposes. When
enabled, the sonar will provide special information on an ethernet
port. This button replaces the
Wind speed button. (► Scientific
Output on page 149)
Fish alarm: This function makes it possible to set up the sonar to
warn you when a school of fish are detected inside the selected
sector. The selected sector is displayed with white dashed lines
in the horizontal sonar picture. (► Fish Alarm on page 121)
User setting: This function is used to store the parameter settings
for different type of fisheries, or individual user related settings.
Default Setting: Click this button to retrieve the default factory
settings. (► Default Setting on page 115)
164385/E 85