Installation manual

Operational procedures
Note
In principles you can use any name, but the Mode buttons on the
Operator Panel will only choose from User 1, User 2, User 3
and User 4. These names must also be on the top of the list. If
you wish to add users, apply names like for example “User 5
Charlie”.
1 Click the Setup tab to open the menu.
2 Click the
User setting button to open the parameter dialogue.
3 Click the one of the user settings on the list to select it.
4 Click the
Rename button.
• Observe that a parameter dialogue opens to present the
current name.
• Observe that an on-line keyboard opens to allow you to
enter characters.
5 Place the cursor at the beginning of the current name, a nd
click the
Del (Delete) button on the on-line keyboard to
remove the characters.
6 Click the necessary characters on the on-line keyboard to
build a new name.
7 Click the
OK button in the parameter dialogue when you
have completed the new name.
8 Click the
Close button in the User Setting parameter dialogue
when you have completed the procedure.
The new name is saved automatically.
How to delete a user setting
Observe the following procedure to delete a predefined user
setting.
1 Click the
Setup tab to open the menu.
2 Click the
User setting button to open the parameter dialogue.
3 Click the desired user setting to select it.
4 Click the
Delete button.
5 Click
OK in the next parameter dialogue to confirm the
selection.
The selected user setting is deleted.
How to load the factory settings
Observe the following procedure to load the predefined factory
settings.
164385/E 51