Installation manual

Simrad SH80
Howtoaddatargettrackingline
Observe this procedure to add a tracking line to a tracked target
to indicate its movement history.
1 Choose an operational mode with a horizontal presentation.
2 Place the cursor in the horizontal presentation.
3 Press the
View button in the Cursor fi eldontheOperating
Panel.
4 Observe that a short-cut menu appears on the display.
5 Click
View Menu, and observe that the GeoView menu opens.
6 Click the
Target track button on the GeoView menu.
7 Observe that the
Target track parameter dialogue opens
below the menu.
8 Choose the length of the tracking line, and click
Close to exit.
User setting procedures
This section explains how to handle user and default settings
on the SH80 sonar.
How t o save the current user setting
Observe the following procedure to save the current user settings.
1 Click the Setup tab to open the menu.
2 Click the
User setting button to open the parameter dialogue.
3 Click the
Save current setting button.
The current setting is saved w ith the default identification name.
How to load a user setting
Observe the following procedure to load a predefined user setting.
1 Click the
Setup tab to open the menu.
2 Click the
User setting button to open the parameter dialogue.
3 Click the desired user setting to select it.
4 Click the
Load button.
5 Click
OK in the next parameter dialogue to confirm the
selection.
The selected setting is loaded.
How to rename a user setting
Observe the following procedure to rename a user settings.
50 164385/E