Installation manual

Simrad SH80
How to start the horizontal search program
Observe the following procedure to run the automatic search
program.
(CD015022H)
TRAIN
Target
Track
Position
Track
Manual
Auto
Search
1 Press the Auto search buttonintheTrain field on the
Operating Panel to start the horizontal search program.
2 Hold the
Auto search button depressed while you also press
one of the two
“arrow” buttons in the Train field.
3 Observe that the opening angle of the search sector is
adjusted accordingly.
4 Release the
Auto search button, press and hold one of the
two
“arrow” buttons.
5 Observe that the centre of the search sector is trained
accordingly.
To exit the search program, press the
Manual button.
How to start the vertical search program
Observe the following procedure to run the automatic search
program.
(CD015022I)
TILT
Auto
Manual
1 Press the Auto button in the Tilt field on the Operating Panel
to start the vertical search program.
2 Hold the
Auto button depressed while you also press one of
the two
“arrow” buttons in the Tilt field.
3 Observe that the vertical opening angle of the search sector
is adjusted accordingly.
4 Release the
Auto button, press and hold one of the two
“arrow” buttons.
5 Observe that the centre of the vertical search sector is
adjusted accordingly.
To exit the search program, press the
Manual button.
How to enable position track
Observe this p rocedure to initiate a position track.
1 Place the cursor over the desired location.
48
164385/E